When it is on, it can be controlled by an M3 or by inline commands. This set the laser in manual mode where you can control the strength. In Marlin mode you can use the laser controls. Hold down on the display knob for 3 seconds. It should work.Īnother thing you can try is putting your display in Marlin mode. If you go to the first post in this topic, you will find a gcode you can download. For any plugin, you will want to use M03/M05 for turning the lasers on and off. A search for “Inscape laser” will find other plugins. Here is a link to one of them that includes detailed instructions. I’ve not used any of them, so I cannot give you any specifics. If you want to try and do laser work from InkScape, there are multiple plugins for lasers. If you end up using LightBurnand have any issues, post your questions to the forum. You want to set it up for Marlin and using Inline commands. LightBurn is made for laser work, and it has many features that make laser work a joy. It costs about $60 USD, but there is a four-week trial, so you can test it out before buying. Once you have a new enough version of the firmware installed, you can verify your laser is working by turning it on using the display.Īs for software, I highly recommend LightBurn. Instructions on how to update the firmware on an SKR Pro (including links to the firmware) can be found on this page. If it is older than 509, then you will need to update your firmware. If you are running version 509 or above, no firmware changes are required. First, you need to verify what version of the firmware you are using.
0 Comments
Leave a Reply. |